的安装通风设备的必备的事项

发布人：http://www.sftfgd.com   发布时间：2017-05-18 15:00:12

任何工程在施工中主要的就是要保证施工的，当然也在同时保证施工的质量。在通风设备安装的过程中，尤其是一些高空作业的时候，我们应该要采取一些保护的措施。下面，我们就一起来看看通风设备安装的保护。

In the construction of any project, the most important thing is to ensure the safety of construction, of course, at the same time to ensure the quality of construction. In the installation of ventilation equipment, especially some high-altitude work, we should take some measures to protect the safety. Below, we will take a look at the safety of ventilation equipment installation.

在通风设备安装施工前要进行检查，如有问题应及时处理。如要高空作业，那么应系好带，并且空中不能抛掷物品。作业现场，应配有防护装置和消防器材，确保。风管吊装时，其正下方严禁站人。通风设备安装应行试吊，没有问题后再起吊。

Before the installation of ventilation equipment, inspection should be carried out, if any problems should be dealt with in a timely manner. If you want aerial work, you should wear your seat belt and you can't throw objects in the air. Job site should be equipped with safety protection devices and fire protection equipment to ensure safety. The wind pipe lifting, it is prohibited to stand below. The ventilation equipment should be tested first and then hoisted after no problem.

通风设备安装方法可以根据现场实际情况来确定，可以进行整体吊装就位，也可以先把风管一节一节放在支架上，然后逐节连接。风管与防护套管之间，应用柔性材料进行封堵。通风设备安装在进行整体吊装时，通风设备厂要注意先要将风管在地面上连接好，其长度为10到12米，不能太长。

Ventilation equipment installation method according to the actual situation of the scene to determine, can be carried out in integral hoisting, can also be a section of a wind tube placed on the frame, and then connected by section. The flexible material is used to seal between the duct and the protective sleeve. Ventilation equipment installed in the overall lifting, ventilation equipment factory should pay attention to the first to connect the wind pipe on the ground, the length of 10 to 12 meters, can not be too long.

通风设备安装的保护的内容大致就是这样，要注意的是，风管系统全部安装好以后，通风设备厂要进行严密性检验，以检查是否有漏气现象。只有检查合格的才能终交付，否则就要进行返工。

Ventilation equipment installation of security protection is generally the case, it should be noted that after the installation of all the wind pipe system, ventilation equipment factory to conduct strict inspection to check whether there is a leak phenomenon. Only qualified inspection can be delivered at last, otherwise rework will be done.