办公楼大型通风管道的清洗方法？

发布人：http://www.sftfgd.com   发布时间：2020-10-21 14:22:41

办公楼大型通风管道的清洗方法？

Cleaning method of large air duct in office building?

1、对空调通风管道系统进行分层清洗，然后将每层空调管道系统分成若干个清洗施工管段，每段长度不超过30米。

1. First of all, the air conditioning and ventilation duct system is cleaned by layers, and then each layer of air conditioning pipeline system is divided into several cleaning construction pipe sections, each section length is not more than 30 meters.

2、将检测机器人和其他成套设备联机工作，检测机器人从检测风管内的口添加到检测口，以检测风管内部的污染情况，通过监控摄像单元可以从显示的风管内部的污染情况和整个视频检测过程中看到，并随时填写一些相关记录。

2. The detection robot and other complete sets of equipment work online. The detection robot is added from the port in the air duct to the detection port to detect the pollution inside the air duct. Through the monitoring camera unit, the pollution situation inside the air duct and the whole video detection process can be seen, and some relevant records can be filled in at any time.

3、对于小型空调和通风系统的风管，用电动毛刷清理一切，弯曲段和立管的通风，用空气或软毛刷清理空气喷嘴，其清理和清洁工具应与大型电动吸尘器配合使用，以保证风管内的灰尘和杂物能被有效地吸出。

3. For the air duct of small central air conditioning and ventilation system, use electric brush to clean everything, ventilate bending section and riser, clean air nozzle with air or soft brush. The cleaning and cleaning tools should be used together with large-scale electric vacuum cleaner to ensure that dust and debris in the air duct can be effectively sucked out.

4、立式风管清洗:立式风管一般只在空调房或通风井内，针对这种情况打开真空吸尘器底部的风管接口。在高点，用高压鼓风机反复吹洗管子。对于坡度和落差大于38O的风管，用高压风机按照上述方法反复吹扫风管。

4. Cleaning of vertical air duct: the vertical air duct is usually only in the air conditioning room or ventilation shaft. In view of this situation, open the air duct interface at the bottom of vacuum cleaner. At high points, repeatedly blow the pipe with a high-pressure blower. For the air duct with gradient and drop greater than 38O, the high-pressure fan shall be used to repeatedly blow the air duct according to the above method.

5、清洗质量合格后，用气动喷雾器喷洒剂(主要由杀线虫剂、次氯酸钠、表面活性剂等组成)。并在风道内进行处理。

5. After the cleaning quality is qualified, the aerosol sprayer is sprayed with pneumatic sprayer (mainly composed of Nematocides, sodium hypochlorite and surfactant). Disinfection treatment was carried out in the air duct.

6、清洁后，将设备移动到下一个地方，然后重新安装设备以清洁下一个地方。

6. After cleaning, move the device to the next location and then re install the device to clean the next place.

7、下一次清洗时，操作步骤相同，只需将安装除尘器的风口作为风刷的入口，相邻的下一个风口作为除尘器的连接口。将气囊放在吸尘器的后端并密封，用另一个气囊密封清洁的部分，以防止二次污染。

7. In the next cleaning, the operation steps are the same, just take the air outlet where the dust collector is installed as the inlet of the air brush, and the next adjacent air outlet is the connection port of the dust collector. Place the airbag at the back of the vacuum cleaner and seal it. Seal the clean part with another airbag to prevent secondary pollution.