白铁风管能不能作为通风管？

发布人：http://www.sftfgd.com   发布时间：2022-03-21 16:53:30

外观上没有明显的划痕，简单的说就是在白铁风管内表面，我们看不到明显的洞口和折痕，虽然不能说折痕就是坏，但确实影响美观，会让人怀疑质量。通风管厂家

There are no obvious scratches on the appearance. In short, we can't see obvious holes and creases on the inner surface of the white iron air duct. Although we can't say that the crease is bad, it does affect the beauty and make people doubt the quality. Ventilation pipe manufacturer

二是厚度，一般厂家在客户要求下会把普通白铁板材加工成管材，但有些劣质商家会做手脚，用薄板材代替厚板材。

The second is thickness. General manufacturers will process ordinary white iron plates into pipes at the request of customers, but some low-quality merchants will do hands and feet and replace thick plates with thin plates.

那佛山白铁风管能不能作为通风管？

Can Foshan white iron air duct be used as a ventilation pipe?

要了解通风管路现场的工作条件，一般通风管路的要求不太严格，除了一些空气中含有腐蚀性成分的现场应选择不锈钢管。

First of all, understand the working conditions of the ventilation pipeline on site. Generally, the requirements of the ventilation pipeline are not too strict. Except for some sites with corrosive components in the air, stainless steel pipes should be selected.

白色铁风管的制造方法：

Manufacturing method of white iron air duct:

查看风管板放样是否符合风管板制造任务单的要求，划线是否正确，板有无损坏。

Check whether the setting out of the air duct board meets the requirements of the air duct board manufacturing task list, whether the marking is correct and whether the board is damaged.

检查刀片是否有牢固的切削刃装置。

Check whether the blade has a firm cutting edge device.

查看刀片的伸出高度是否与要求相符。直刀刨刀片的伸出高度应能堵住扳材，不会对桌面造成伤害；单刀刨刀片和双刀刨刀片的伸出高度应能堵住上层铝箔和芯材，不会对下层铝箔造成伤害。双面刨刀的间距约2毫米。

Check whether the extension height of the blade meets the requirements. The protruding height of the straight knife planer blade shall be able to block the pulling material and will not cause damage to the desktop; The protruding height of single knife planer blade and double knife planer blade shall be able to block the upper aluminum foil and core material without damaging the lower aluminum foil. The spacing between double-sided planers is about 2mm.

根据切边要求选择左边的45°单刀刨或右边的45°单刀刨。不锈钢通风管道哪家好

Select the 45 ° single blade planer on the left or the 45 ° single blade planer on the right according to the trimming requirements. Which is a good stainless steel ventilation pipe

将铝板置于工作台上，用方铝尺将铝板平行固定在合适的方位。

Place the aluminum plate on the workbench and fix the aluminum plate in a proper position in parallel with a square aluminum ruler.