济南通风管向你介绍如何清理通风管道内的杂质

发布人：http://www.sftfgd.com   发布时间：2018-08-07 11:23:14

通风管道随着使用时间的不断增长，里面会堆积很多的杂质，这些杂质长期存储在管道内，在运转中会加快它的油凝结，温渡过高，构成气压阀、液压等部件的损坏，对正常运转构成很大的影响。所以定期的对通风管道设备进行清理是非常有必要的。如何进行清理呢？西安伟业通风管道下面为您介绍下：
With the continuous increase of the use time, the ventilation pipe will accumulate a lot of impurities. These impurities are stored in the pipeline for a long time. In the operation, it will speed up its oil condensation, temperature exorbitant, the damage of the pressure valve, hydraulic and other components, which has a great influence on the normal operation. Therefore, regular cleaning of ventilation piping equipment is very necessary. How do you clean up? Xi'an Weiye ventilation pipe expert below introduces you:

当风管与风机衔接时，应在进出风口处加软接头，其软接头的断面尺度应与风机进出风口共同。软管接头普通可采用帆布、人造革等材料，软管长度不宜小于200，松紧度应适宜，柔性软管可缓冲风机的振荡。
When the air duct is connected with the fan, a soft joint should be added at the inlet and outlet of the fan, and the cross-sectional dimension of the soft joint should be the same as the inlet and outlet of the fan. The hose joint can be made of canvas, artificial leather and other materials. The hose length should not be less than 200, the elasticity should be suitable, and the flexible hose can cushion the vibration of the fan.
当风道与除尘设备、加热设备等衔接前，应待设备装置终了后，按理论测绘的图纸中止预制和装置。
When the air duct and dust removal equipment, heating equipment, etc. before the connection, should wait for the equipment after the end of the device, according to the theory of mapping drawings to stop the prefabrication and equipment.
济南通风管道装置时，进、出风日宜在风道预制时开出洞口，如需在装置终了的风道上现开风口，其接口处应紧密。
When the air duct is made in Ji'nan, the inlet and outlet should be opened when the air duct is prefabricated. If the vent is needed in the end of the air duct, the interface should be close.
当运送含凝结水或含湿量较大的气体时，其水平管道宜设有坡度，并在低点处接排水管。装置时风道底部不宜呈现纵向接缝，对底部有接缝处应中止密封处置。
When transporting gas containing condensate or large moisture content, the horizontal pipeline should be provided with a slope, and the drainage pipe should be connected at the low point. The longitudinal joint is not suitable for the bottom of the duct, and the sealing treatment should be stopped for the joints at the bottom.
对运送易燃、易爆气体的钢板风道，在风道衔接法兰处应装置跨接线，并与静电接地网衔接。
For the steel plate air duct conveying flammable and explosive gases, the connecting flange of the air duct should be connected with the electrostatic grounding grid.
当水平风道高度在4m以上时，装置人员应系带。脚手架或移动式支架上的跳板应固定好，跳板宽度应契合规范，在脚手架上的装置人员宜携东西袋，避免东西或电钻等物掉落伤人。
When the height of the horizontal airway is above 4m, the installation personnel should fasten the seat belt. The springboard on the scaffold or the movable support should be fixed. The width of the springboard should be in accordance with the safety specification. The device personnel on the scaffold should carry the bag to avoid the thing or the electric drill.
双吊杆支架在风道就位后，应保证横担平直，吊杆不改动，双吊杆受力均匀。
When the double hanger bracket is positioned in the air duct, the cross arm shall be straight and the boom shall not be changed, and the double hangers should be evenly distributed.
通风管道较好是三个月进行一次清洁，这样既可以保证平时正常的运转，还可以延长通风管道的使用寿命，对于清洁这方面的问题还有不明白的，可以通过我们的官网电话咨询我们，我们会及时给您回复。
The best ventilation pipe is three months to carry out a comprehensive cleaning, so that it can ensure normal normal operation, but also prolong the service life of the ventilation pipe, and do not understand the problem of cleaning this aspect. We can consult us by our official network telephone, we will respond to you in time.