全部通风工程需求和水帘作用介绍

发布人：http://www.sftfgd.com   发布时间：2023-04-14 18:10:19

  风管就位前应查看全部支架的水乎度和标高、查看支架的牢固程度，风管就位可采用直接和吊具两种办法。对风管断面较小，又方位较低的可采用人工就位办法，只需搭设简易脚手架即可。当风管断面较大且管段较长时，可采用滑轮、倒链、大绳等办法吊装。

Before placing the air duct in place, the water level and elevation of all supports should be checked, and the firmness of the supports should be checked. There are two methods for placing the air duct: direct and lifting. For ducts with small cross-section and low orientation, manual positioning can be used, which only requires the installation of simple scaffolding. When the cross-section of the air duct is large and the pipe section is long, methods such as pulleys, chain blocks, and large ropes can be used for lifting.

主要靠纤维渗透和喷孔射流的独特出风模式能均匀送风的送出风末端系统。具有面式出风，风量大，无吹风感；整体送风均匀分布；防凝露；易清洁维护，健康；美观、色彩多样，个性化突出；重量轻，屋顶负重可忽略不计；系统运行宁静，改善环境品质；安装简单，缩短工程周期；安装灵活，可重复使用；系统成本节省，性价比高等种种优点。

A unique air outlet system that relies mainly on fiber infiltration and orifice jet to evenly distribute air. Equipped with surface style air outlet, with high air volume and no blowing sensation; Uniform distribution of overall air supply; Anti condensation; Easy to clean and maintain, healthy and environmentally friendly; Beautiful, colorful, and personalized; Lightweight, with negligible roof load; Quiet system operation, improving environmental quality; Easy installation and shortened engineering cycle; Flexible installation, reusable; The system has various advantages such as comprehensive cost savings and high cost-effectiveness.

全部通风工程需求和水帘合作运用，在夏日酷热的时分可将车间内温度控制在28摄氏度以内。但人体的凉快感受可与空调比较，稍长时间对着水帘的人会感受冷而受不了。

All ventilation projects require cooperation with water curtains, and the temperature in the workshop can be controlled within 28 degrees Celsius during the scorching summer heat. But the coolness of the human body can be compared to air conditioning, and people who face the water curtain for a slightly longer time will feel cold and cannot bear it.

济南通风管道在运输过程应有防止损伤风管的保护措施。榫接风管的连接在榫口处涂胶粘剂，是为增强接头处的强度。当风管采用地面预组装后架空安装时，限制预组装的长度是为了遮免风管因自重产生的弯曲而破坏构件接口。玻璃纤维复合板风管端口为切割面时，在装配法兰连接件前应将管端切口面用胶带或胶液进行封堵，才能防止玻璃纤维外露和飞散。

Ventilation ducts should have protective measures to prevent damage to the ducts during transportation. The connection of the mortise and tenon air duct is coated with adhesive at the mortise to enhance the strength of the joint. When the air duct is installed overhead after ground pre assembly, limiting the length of pre assembly is to prevent the bending of the air duct due to its own weight from damaging the component interface. When the end of the fiberglass composite board air duct is a cutting surface, the cutting surface of the pipe end should be sealed with tape or glue before assembling the flange connection to prevent the exposure and scattering of the fiberglass.

更多的关于济南通风管道问题或者详细的内容，请进入我们公司的网站：http://www.sftfgd.com网站中会有很多的内容仅供参考。

For more information or detailed information on the issue of ventilation ducts in Jinan, please visit our company's website: http://www.sftfgd.com There will be a lot of content on the website for reference only.